User Interface
The software interface of Flash Programmer is in dialogue page form:
Flash Programmer consists of three dialogue pages:
1. Program, which shows the current data of the ARM processor and Flash chip information, and sets up partial programming data.
2. CPU, which selects ARM processor, configure the register, memory and conducts target test, etc.
3. FLASH, which selects Flash chips, sets up access width and number of
chips.
CPU sub-dialogue is used to set ARM series processor used by the user, to set the CPU register, write data to designated memory area and select endian mode. Users may read the register and test the target in this dialogue.
The Flash sub-dialogue box is used for setting FLASH chip type used by a user, data bus access width, number of chips, FLASH start address and sector operation range.
>>Back to Flash programmer<<
|
Home
